Owner`s manual

programming a new transmitter/receiver

The system comes with two transmitters that have been taught to the

receiver. The receiver can store up to 4 different transmitter codes in

memory. Use the following procedure to add transmitters to the system.

1. Open the driver’s door

2. Turn the ignition on.

3. Enter transmitter program: Press and

release the integrated LED/Valet

switch once.

Then press and hold the integrated LED/Valet

switch once more. The horn will chirp and the

LED will blink once. Continue to hold the switch

and proceed to step 4.

4. Press the arm button: While holding

the integrated LED/Valet

switch, press the

button. The unit will chirp indicating successful

programming. The transmitter is now set to the standard configura-

tion. Refer to the Standard Configuration section of this guide.

5. Additional transmitter program: If you wish to program an addi-

tional transmitter, repeat steps 1 through 4. Remember that the system

will only accept a maximum of 4 different transmitters.