Installation guide

H1/3 WHITE/BLUE -) 200 mA channel 3 output: This wire supplies a (-) 200 mA out-

put whenever the button on transmitter programmed for channel 3 is pressed. This out-

put is used to control optional accessories. This channel can be programmed to pro-

vide the following types of output (see feature programming section of this guide).

1. A validity output will send a signal as the transmission is received.

2. Second unlock output when the unlock button is pressed a second time after

disarming the system. This can be used to unlock the passenger doors when

installing progressive door locks.

IIMMPPOORRTTAANNTT!!

Zones 2 and 4 are shunted when this channel becomes active. Zones

2 and 4 reactivate 5-seconds after this output ceases.

NNOOTTEE::

Other features can be programmed to channel 3 using the Bitwriter

H1/4 BLACK/WHITE (-) 200 mA domelight-supervision output: Connect this wire to

the optional domelight supervision relay.

IIMMPPOORRTTAANNTT!!

This output is only intended to drive a relay. It cannot be connected

directly to the domelight circuit, as the output cannot support the current draw of one

or more bulbs.

LIGHT BULB

PARKING LIGHT

RELAY OR SWITCH

(+) 12V

WHITE H1/2

(-) LIGHT FLASH OUTPUT