Installation guide

H1/11 RED (+)12V constant power input: Before connecting this wire, remove the

supplied fuse. Connect to the battery positive terminal or the constant 12V supply to

the ignition switch.

NNOOTTEE::

Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use

the 15A fuse in the harness for this purpose. This fuse protects the module itself.

H1/12 RED/WHITE (-) 200mA auxiliary channel/delayed accessory output: If pro-

grammed for an auxiliary output, this wire will provide a (-) pulse when the lock but-

ton on the factory transmitter is pressed twice within three seconds. This output can be

used to control optional accessories. If programmed for delayed accessory output, this

wire will provide (-) ground when the ignition is turned off and will continue to output

(-) ground until a door is opened then closed. This can be used to energize the acces-

sory circuit in the vehicle to keep the radio and other accessories on after the ignition

is turned off.

IIMMPPOORRTTAANNTT!!

Never use this wire to drive anything but a relay or a low-current input!

This transistorized output can only supply (-) 200 mA, and connecting directly to a sole-

noid, motor, or other high-current device will cause the module to fail.

NNOOTTEE::

Zones 2 and 4 are shunted when this channel becomes active. Zones 2 and

4 reactivate 5-seconds after this channel’s output ceases.