Installation guide

H2/6 VIOLET/BLACK (-) 200 mA channel 4 output: This wire supplies a (-) 200 mA

output whenever the button on transmitter programmed for channel 4 is pressed. This

output is used to control optional accessories.

IIMMPPOORRTTAANNTT!!

Zones 2 and 4 are shunted when this channel becomes acttive. Zones

2 and 4 reactivate 5-seconds after this output ceases.

H2/7 YELLOW/BLACK no function.

door lock harness wire connection guide

___

The control module can control 2 common power door lock types without any addition-

al parts. With certain verhicles, or if an actuator is to be installed, either a 451M Door

Lock Relay Satellite or two relays will be required. Refer to TechTips document 1041.

plug-in harnesses

integrated LED/Valet

switch

The integrated LED/Valet

switch should be accessible from the driver’s seat. The

Valet

part of the integrated LED/Valet

switch plugs into the blue port on the side of

the unit. Check for rear clearance before drilling a 5/16-inch hole and mounting the

switch. The LED part of the integrated LED/Valet

switch operates at 2V DC and plugs

into the white port on the side of the unit. Make sure the LED wires are not shorted to

ground as the LED will be damaged.

data port—Bitwriter

The black three-pin port can be used for programming the unit or to accommodate a

serial controller. The Bitwriter

is available for programming through this port.

BLUE (-) Unlock, (+) Lock Output

Not Used

GREEN (-) Lock, (+) Unlock Output

H3/A

H3/B

H3/C