Installation guide

as a shut-down.

Testing the Neutral Safety Switch

1. Make sure there is adequate clearance to the front and rear of the vehicle because it may move

slightly.

2. Make sure the hood is closed and there are no remote start shut-downs active.

3. Set the emergency brake.

4. Turn the key to the "run" position, this will release the shifter.

5. Place the car in drive (D).

6. Place your foot directly over the brake pedal, but do not depress it. Be ready to step on the brake

if the starter engages.

7. Activate the remote start system.

8. If the starter engages, immediately depress the brake to shut the remote start system down. If

the starter does not engage, no additional safety system is required.

If the starter engages while testing, refer to technical document #1008 (Neutral Safety Update). It

is available to authorized dealers only from the technical resources listed at the beginning of this

manual.

Door Lock Harness (H4),

Wire Connection Guide

___

Blue (-) Unlock, (+) Lock Output

Empty Unless Using 451M

Green (-) Lock, (+) Unlock Output

H4/A

H4/B

H4/C

IMPORTANT! Once the interface is complete, attempt to remote start the vehicle with

the door closed and the key in the ignition. The vehicle should not start. If it does,

recheck the connections.

2003

Directed Electronics, Inc.