User guide

;------------Win2K and Win9x Device List-------------------------
[Broadcom]
; very generic Broadcom 4401 A1 NIC or LOM
%BCM4401.DeviceDesc% = BCM4401, PCI\VEN_14E4&DEV_4401
.
.
; MSI LOM
%BCM4401_msi_two.DeviceDesc% = BCM4401_msi_two, PCI
\VEN_14E4&DEV_4401&SUBSYS_590C1462
;----------end of Win2k and Win9x Device List-------------
b. Remove NTx86.5.1 in two locations (see the following example).
Original Revised
[Manufacturer]
%V_BCM% = Broadcom,
NTx86.5.1
[Broadcom.NTx86.5.1]
[Manufacturer]
%V_BCM% = Broadcom
[Broadcom]
3. Follow the steps in the Microsoft Knowledge Base Article - 315279 at
http://support.microsoft.
com/default.aspx?scid=kb%3ben-us%3b315279, skipping step 1, as shown above.
Broadcom Boot Agent
Problem: Unable to obtain network settings through DHCP using PXE.
Solution: For proper operation make sure that the STP (spanning tree protocol) is disabled or that
portfast mode (for Cisco) is enabled on the port to which the PXE client is connected. For instance, set
spantree portfast 4/12 enable.
Back to Contents Page