Programming instructions

11
© 2004 directed electronics, inc.
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release
.
b. To enter valet mode: Press and hold
for
three seconds.
The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press for one second.
The LED will turn off.
transmitter valet mode
The operations described in this section refer to transmitter buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration transmitter. This may not be how
your transmitter is set up.
To enter Valet Mode, press and . The LED status indicator
will light solid if you are entering Valet Mode, or will turn off if you are
exiting Valet Mode.