Installation guide

rreellaayy wwiirreess ((hheeaavvyy ggaauuggee))

66--ccoonnnneeccttoorrss

—

pprriimmaarryy hhaarrnneessss ((HH11)) ddeessccrriippttiioonn

HH11//11 BBLLUUEE

(-) 200 mA status output

Provides a 200mA output as soon as the control module begins

the remote start process. This wire can be used to activate an

immobilizer bypass unit.

HH11//22 VVIIOOLLEETT//WWHHIITTEE

tachometer input

This input provides the control module the engine rpm data.

This wire is connected to the negative side of the ignition coil in

vehicles with conventional ignition coils. In multi-coil and high

energy ignition systems, locating a proper signal may be more

difficult. (See Finding the Wires You Need section of this guide

for finding the tachometer wire.)

PINK/WHITE (+) Output to Ign2/Acc2 Circuit

RED (+) 12V Input 30A Fused

PINK (+) Output to Ignition Circuit

ORANGE (+) Output to Accessory Circuit

RED (+) 12V Input 30A Fused

PURPLE (+) Output to Starter Circuit