Installation guide

15
© 2004 Directed Electronics, Inc.
temporarily (i.e., for service on the vehicle or when parking in an
enclosed area). This switch is to be mounted in an easily acces-
sible location in the passenger compartment.
Connect the toggle switch as shown below.
HH11//55 BBLLAACCKK
ground
Remove any paint and connect this wire to bare metal, prefer-
ably with a factory bolt rather than your own screw. (Screws tend
to either strip or loosen with time.) We recommend grounding
all your components to the same point in the vehicle.
note: More problems are attributed to poor ground con-
nections than any other cause. Take extra care to ensure
the ground is a clean metal-to-metal contact and secure.
BYPASSED WHEN CLOSED
BYPASS
TOGGLE
SWITCH
TO GRAY (H1/5) WIRE
ON
CONTROL MODULE
HOOD PIN SWITCH -
OPEN WHEN HOOD IS CLOSED
HOOD PIN SWITCH -
CONNECTOR