Installation guide

19
© 2004 Directed Electronics, Inc.
wrap with electrical tape.
FF––PPIINNKK//WWHHIITTEE
(+) output to ignition2/accessory2 circuit
Connect this wire to the second ignition or accessory wire in the
vehicle.
lleeaarrnniinngg ttrraannssmmiitttteerr
The system comes with one transmitter. The receiver can store
up to 4 different transmitter codes in memory. Use the following
to learn the transmitter or to add a transmitter to the system.
The following is the basic sequence of steps to remember whenever
programming this unit:
1.
KKeeyy..
Turn the ignition to the ON position.
2.
PPrrooggrraamm..
After 5-seconds, press and
hold both buttons on the transmitter, until—(see step 3).
3.
PPaarrkkiinngg LLiigghhttss FFllaasshh..
The parking lights will flash twice to
acknowledge programming of this transmitter.
note! The WHITE/BLUE (H1/6) wire, (-) remote start
activation input, from the primary harness is used for
testing purposes. Contact Directed Technical Support for
additional information.
note: For vehicles that do not have a second ignition or
accessory wire, this connection is not required.