Installation guide

20
© 2004 Directed Electronics, Inc.
To add a second transmitter (within 5-seconds of the first trans-
mitter parking light flash learn acknowledgment):
1.
PPrrooggrraamm..
Hold the both buttons on the additional trans-
mitter for an additional 5-seconds, until—(see step 2).
2.
PPaarrkkiinngg LLiigghhttss FFllaasshh..
The parking lights will flash twice to
acknowledge programming of this transmitter.
tteessttiinngg tthhee ssyysstteemm
Once installation and transmitter learn have been completed,
the operation of the system can be tested.
Place the two 30-amp fuses back into the relay harness red wire
fuse holders. Make sure that the vehicle is in park with the emer-
gency brake on and the hood closed. Press once on the
remote control to initiate the remote start function. The parking
lights should flash to confirm the remote start command has
been received, The accessories and ignition should turn on
followed by the starter cranking and the vehicle engine running.
Pressing on the remote will shut the engine off.