Operating instructions

Application
▶ Standard
Interface
à Select the requested application with [–>] and save your
settings with [OK]. Then move to the menu item Input with
"[–>]".
Because VEGAMET 625 has two inputs, the measurement
loops must be assigned to the inputs. After the addresses of
the HART sensors are assigned, a list with the existing
sensors can be prepared and displayed via "Sensor selection
– Sensor search". Now you can assign the requested sensor to
each measurement loop.
Input 1
undefined
Change input?
VEGAMET 625 must be informed which "Sensor value" für die
Weiterverarbeitung verwendet werden soll. Je nach Sensortyp
kann dies Distanz, Druck, Trennschicht oder Temperatur sein.
Beim Anschluss von HART-Sensoren anderer Hersteller
stehen unter anderem die Auswahlmöglichkeiten PV (Primary
Value) und SV (Secondary Value) zur Verfügung. Welche
Messgröße hierbei übertragen wird, muss aus der Betriebs-
anleitung des jeweiligen Sensorherstellers entnommen wer-
den.
à Allocate the requested inputs to the appropriate measure-
ment loops, select the suitable sensor value and save your
settings with [OK]. After the first setup, you can modify the
inputs als under "Meas. loop – Input".
You can assign an unambiguous name to VEGAMET 625 via
the Device-TAG. This function is recommended when several
VEGAMETs are implemented and a good documentation of
larger system is required.
Device settings – Input
Device settings – Device-TAG
20 VEGAMET 625 - Double channel Hart signal conditioning instrument
Setup with the integrated indicating and adjustment unit
28970-EN-050616