Operating instructions

Current output 1
Basic meas. value: %
▼
Characteristics: 4 … 20
mA
▼
Failure mode: 22 mA ▼
à Enter the requested parameter via the appropriate keys
and save your settings with [OK].
In the menu item "Display", you can set the requested
displayed value for the measurement loop.
Displayed value
Percent
▼
à Enter the requested parameter via the appropriate keys
and save your settings with [OK].
If the instrument displays a fault, further information can be
retrieved via the menu item "Diagnostics – Device status –
Add. information".
Sensor status
E007
Sensor type not compatible
The service menu contains the following settings:
l Simulation of the measured value
l Reset
l Set display language
l PIN to block the menu
l Change HART sensor address
à Enter the requested parameter via the appropriate keys
and save your settings with [OK].
Under this menu item you can assign and modify the HART
addresses of the connected sensors.
Display
Diagnostics
Service
Service – Change sensor
address
26 VEGAMET 625 - Double channel Hart signal conditioning instrument
Setup with the integrated indicating and adjustment unit
28970-EN-050616