Operating instructions

18
6 Setup with the integrated display and adjustment unit
VEGAMET 625 • Double channel HART
28970-EN-150129
Afterbeingswitchedon,VEGAMET625rstofallcarriesoutashort
self-check. The following steps are carried out:
•
Internal check of the electronics
•
indicationoftheinstrumenttype,rmwareversionaswellasthe
instrument TAG (instrument name)
•
Theoutputsignalsjumpbrieytothesetfaultvalue
After the assignment of the addresses to the sensors, the current
measured values will be displayed and outputted.
As requested, the measured value display shows the individual
measurement loops separately or in a joint overview. The respective
digital display value, the measurement loop name (meas. loop TAG)
and the unit are shown. With the separate presentation, an analogue
bar graph is also displayed and the measured values appear in big-
gerfontsize.Bypushingthe[>]key,youmovebetweenthedierent
indicating options.
Note:
Dependingonthecongurationanduseofallmeasurementloops,
thecycletimeforthemeasuredvaluetransmissioncantakeuptove
seconds.
By pushing [OK] you move from the measured value indication to the
main menu.
The main menu is divided into six areas with the following functions:
•
Device settings: Includes the device-TAG, settings for network
connection such as date/time setting, …
•
Measurement loop: Includes settings for input selection, adjust-
ment,damping,linearization,scaling,outputs,…
•
Display: Includes settings to the displayed measured value
•
Diagnosis Includes information to the device status, error mes-
sages
•
Service Includes simulation, reset, PIN, selectable language,
sensor address, …
•
Info: Shows serial number, software version, last change, instru-
ment features, MAC addr., …
Switch-on phase
Measured value indica-
tion
Main menu