Operating instructions

20
6 Setup with the integrated display and adjustment unit
VEGAMET 625 • Double channel HART
28970-EN-150129
name. By default, the host name consists of the serial number plus
"VEGA-"infront.Asanalternative,itisalsopossibletoenterastatic
IP addr. with Subnet mask and optional Gateway addr.
Note:
Keepinmindthatyourmodicationwillbeonlyeectiveafterarestart
ofVEGAMET625.Youcanndfurtherinformationofthesenetwork
parametersinthesupplementaryinstructions"RS232/Ethernet con-
nection"andintheOnlinehelpoftherespectiveDTM.
Carry out your settings via the appropriate keys and save with [OK].
→
Carry out your settings via the appropriate keys and save with
[OK].Disconnectbrieytheoperatingvoltagesothatthemodi-
edsettingsbecomeeective.
Date and time can be entered in this menu item for instruments with
integratedRS232/Ethernetinterface.Thesetimesettingsarebuered
in case of power failure for approx. 3 days.
→
Enter the values via the appropriate keys and save your settings
with [OK].
For instruments with integrated RS232 interface, you determine here
which mode this serial interface should operate in. The following op-
tions are available:
•
VVO protocol: Direct standard connection between signal condi-
tioning instrument and PC for parameter adjustment and enquiry
(e.g. with PACTware and DTM)
•
PPP: Dial-up connection between signal conditioning instrument
and modem for independent transmission of e-mails (dial-out con-
nection) or enquiry via web browser (dial-in connection)
•
ASCII protocol: Direct standard connection between signal con-
ditioning instrument and PC for enquiry with terminal programs,
e.g. Hyperterminal
Device settings - Time/
Date
Device settings - Commu-
nication protocol