Specifications

PN 718113AF
vii
Safety Notice
FCC Class A Compliance
CAUTION
Do not attempt to load or remove labware manually while the instrument is in
operation.
WARNING
Do not spill liquids on or around the instrument. Wipe up any spills immediately.
WARNING
To avoid serious damage to the instrument, make sure that the laboratory site
voltage/frequency matches the voltage/frequency that was ordered for the
instrument.
WARNING
Do not attempt to remove or replace covers while the unit is powered on;
disconnect power before removing or replacing the cover.
WARNING
Avoid direct exposure to the laser beam. Never look directly into the laser beam,
and never leave the laser on, open, and unattended.
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
EMI Compliance
THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS A LIMITS FOR THE RADIO NOISE
EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS
OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.