Owner`s manual

A MC INPUT: Input for a Moving Coil phono cartridge. Connect the twin

RCA lead from your turntable to this input if you are using a Moving Coil

cartridge.

B MC-MM SWITCH: Slide this switch to either MM (Moving Magnet) or

MC (Moving Coil) depending upon the Phono cartridge being used.

C PHONO GROUND CONNECTOR: Turntables normally includes a single

wire earth lead. Use the C 356BEE Phono ground connector to connect

this lead. Unscrew the terminal to expose the hole, which will accept

the lead. After insertion, tighten the terminal to secure the lead.

D MM INPUT: Input for a Moving Magnet Phono cartridge. Connect

the twin RCA lead from your turntable to this input if you are using a

Moving Magnet cartridge.

IDENTIFICATION OF CONTROLS

REAR PANEL

A B C D

19 MDC CLASSIC UPGRADE SLOT: Remove cover to install the

optional Modular Design Construction (MDC) module. An example

of a C 356BEE-compatible MDC Classic module is the PP 375 Phono

Preamplier module. The PP375 is integrated into the chassis of the

C 356BEE, automatically assigned to the DISC input and its level well

matched to the other sets of line level input.

Consult with your NAD dealer on how to procure the PP375 and

its consequent installation to the C 356BEE. Check out also the NAD

website for any announcement about future release(s) of other

C 356BEE-compatible MDC Classic modules.

With the optional PP 375 installed, refer below for descriptions of key

PP375 parts.

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ