Installation guide

secondary harness (H2) wire connection guide

This wire sends a negative pulse every time the remote start is activated. This can be used to pulse the disarm

wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown

in the diagrams below. This wire can also be used as a special accessory output. (See Feature Descriptions section

of this guide.)

Relay for Negative (-) Disarm Wire Relay for Positive (+) Disarm Wire

This wire provides a (-) 200mA output when the remote start shuts down.

This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 4 is pressed. This

output can be programmed to provide the following types of outputs (see also the Feature Menus section):

■ Validity: Output that will send a signal as long as the transmission is received.

■ Latched: Output that will send a signal when the Channel 4 button(s) is pressed and will continue until the

same button(s) is pressed again.

■ Latched, reset with ignition: Similar to the latched output, this type of output turns on the first time the

Channel 4 button(s) is pressed and turns off the next time the same button is pressed. This type of output

additionally stops and resets whenever the ignition is turned on and then off.

■ 30-second timed: Output that will send a continuous signal for 30 seconds.

■ Second unlock output: This output can also be programmed to provide a second unlock pulse whenever the

disarm button is pressed within 15 seconds after disarming the system. This setting could be used to unlock

H2/3 VIOLET/BLACK 200 mA (-) programmable channel 4 output

H2/2 GREEN/WHITE factory alarm rearm

H2/1 LIGHT GREEN/BLACK (-) factory disarm output