Installation guide

© 2003 Directed Electronics, Inc. Vista, CA 25
Connect this wire to the second ignition wire in the vehicle. (See Finding the Wires You Need section.)
NOTE: For vehicles that do not have a second ignition wire, this connection is not required.
Connection for high current outputs.
remote start secondary harness (H3) wire
connection guide
This wire supplies a 200mA output as soon as the module begins the remote start process. It can be used with
a relay to disconnect a sensor from the system as shown below. The H3/1 BLUE wire can also be used to rearm
a factory anti-theft system when the remote start shuts down. (See the Feature Descriptions section of this guide.)
To bypass an optional sensor:
This wire MUST be connected to hood pinswitch. This input will disable or shut down the remote start when the hood
is opened. It will also trigger the security system if the hood is opened while the system is armed and report Zone 1.
H3/2 GRAY (-) hood pinswitch input, zone 1
SENSOR TRIGGER OUTPUT
SENSOR INPUT OF SYSTEM
(+) 12V FUSED
CUT
85
86
30
87
87A
DIA-141
H3/1 BLUE STATUS
OUTPUT
H3/1 BLUE/WHITE (-) status output
RED/WHITE (+) 12V input
PINK/WHITE (+) second ignition output