Installation guide

3-8 ACTIVATION PULSE COUNT: This allows the system to use 1 or 2 pulses to activate the remote start

sequence.

Note! 1 or 2 pulses on the WHITE/BLUE remote start activation input wire as well as the

button of the remote control.

3-9 2

IGNITION/2

ACCESSORY OUTPUT: This will allow the PINK/WHITE to be used as a 2

ignition or

an accessory.

3-10 ACCESSORY STATE DURING WAIT-TO-START: This feature will allow the selection of the accessory output

to be ON or OFF during wait-to-start.

3-11 2nd STATUS OUTPUT: This feature will allow selection of status ouput or a rear defogger mode that turns

on ten seconds after the vehicle has started. The defogger mode has two selections, latched or pulsed. Latched

mode will only stay on for 5 minutes.

3-12 ANTI-GRIND ON/OFF: With the anti-grind On (default) the ground-when-armed output will be active

during remote start operation. If accessories such as a voice module or window module are added to the unit, it

may be necessary to program this feature off.

nuisance prevention circuitry

™

NPC™ requires that you change the way you test the system as NPC™ will bypass an input zone for 60 minutes.

If the system “sees” the same zone trigger three times AND the triggers are spaced less than an hour apart, the

system will bypass that input zone for 60 minutes. If that zone does not attempt to trigger the system during

the 60-minute bypass period, the zone’s monitoring will begin again at the end of the hour. If it does attempt

to trigger while bypassed, the 60-minute bypass starts over again.

Disarming and rearming the system does not reset NPC™. The only way to reset NPC™ is for the 60 minutes to

pass, without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered,

disarmed and rearmed, and still allow NPC™ to bypass a faulty zone.

When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been

bypassed. (See Diagnostics section of this guide.)