Specifications

TM 11-5820-670-30
2-47. POWER SUPPLY CIRCUIT CARD REPLACEMENT. (CONT)
4. Using soldering iron, unsolder wires as shown in circuit card wiring table below.
CIRCUIT CARD WIRING TABLE
WIRE COLOR
INDEX NO.
WHT/ORG
WHT/RED
BLK
WHT/BLU
WHT
RED
WHT/GRN
5
6
7
8
9
10
11
5. Remove circuit card (4).
INSTALLATION
CAUTION
Care must be taken when performing next step to prevent damaging printed circuit
board.
1. Using soldering iron, solder wires as shown in circuit card wiring table above.
2. Position circuit card (4) on studs and install four locknuts (3).
3. Using wrench, tighten four locknuts (3).
4. Close assembly (2) and install three shouldered screws (1).
5. Using screwdriver, tighten three shouldered screws (1).
FOLLOW-ON MAINTENANCE: Install case (para 2-39).
2-179