User manual

1200 Series Variable Wavelength Detector User Manual 133
Index
special settings, 55
specifications
performance, 25
physical, 24
spectra
online, 56
stable baseline, 47
stack configuration, 30, 32
rear view, 32
standards, 24
status indicators, 72, 74
stop time, post time, 50
stop-flow condition, 56
T
test functions, 72
tests
holmium oxide, holmium oxide
test, 105
intensity of lamp, 102
wavelength calibration, 104
time table, 50
troubleshooting
Agilent LC diagnostic software, 76
diagnostic signals, 72
error messages, 72
overview, 72
status indicator, 74
status indicators, 72, 73
test functions, 72
user interfaces, 75
turn on,automatic, 55
U
unpacking, 28
user interfaces
ChemStation, Control Module, Instant
Pilot, 75
using
additional signals (diagnostics), 50
Agilent ChemStation, 45
analog output range, 55
analog output settings, 59
at power on, 55
attenuation, 50
autobalance, 50
automatic turn on, 55
data rate, 62
detector parameters, 49
drift, 47
EMF, 18
enable analysis when lamp is off, 60
error method, 55
isocratic test sample, 54
lamp type, 55
load method, 48
negative absorbance, margins, 60
online plot, 52
online spectra, 56
peakwidth setting, 50
peakwidth settings, 61
preparing the HPLC system, 45
priming and purging the system, 40
requirements and conditions, 42
response time, 62
running the sample, 54
sample info, 53
scan range / step, 60
scanning, 57
setting up an analysis
, 40
setup of detector, 49
signal plot, 51
signal polarity, 60
special setpoints, 50, 60
special settings, 55
stable baseline, 47
stop and post time, 50
stop-flow condition, 56
the cuvette holder, 94
the detector, 39
time table, 50
turn on, 46
typical chromatogram, 44
warm up, 47
zero offset, 50
UV-radiation, 126
W
warm up, 47
warnings and cautions, 79
wavelength
accuracy, 25
calibration, 104
range 190-600 nm, 25
recalibration, 72
weight, 24
Z
zero offset, 50