User manual

parameters vacon • 97
24-hour support [phone] • Email: [e-mail]
8
When ProfidBus E3/E5 board has been installed, the comm. Parameters are as follows
V2.1 Communication status 14022
V2.2 Fieldbus protocol status 14023
V2.3 Active protocol 14024
V2.4 Active buad rate 14025
V2.5 Telegram type 14027
P2.6 Operate mode 1 3 1 14021
1 = Profidrive
2 = Bypass
3 = Echo
P2.7 Slave address 2 126 126 14020
When OPT-BH board has been installed, the comm. Parameters are as follows
P2.1 Sensor 1 type 0 6 0 14072
0 = No Sensor
1 = PT100
2 = PT1000
3 = Ni1000
4 = KTY84
5 = 2 x PT100
6 = 3 x PT100
P2.2 Sensor 2 type 0 6 0 14073
0 = No Sensor
1 = PT100
2 = PT1000
3 = Ni1000
4 = KTY84
5 = 2 x PT100
6 = 3 x PT100
P2.3 Sensor 3 type 0 6 0 14074
0 = No Sensor
1 = PT100
2 = PT1000
3 = Ni1000
4 = KTY84
5 = 2 x PT100
6 = 3 x PT100
When OPT-EC board has been installed ,the comm. Parameters are as follows
V2.1 version number 0
Version number of the
board software
V2.2 Board status 0
State of the OPTEC
board application
Code Parameter Min Max Default ID Note
Table 8.19: System parameters