User manual

control panel vacon • 63
24-hour support [phone] • Email: [e-mail]
7
7.4.3 Monitoring menu
Figure 7.4: Monitoring menu display
Monitoring values are actual values of measured signals as well as status of some
control settings. It is visible in Vacon 20 display, but it can not be edited. The moni-
toring values are listed in Table 7.2.
Pressing Left/Right button to change the actual parameter to the first parameter of
the next group, to browse monitor menu from V1.x to V2.1 to V3.1 to V4.1. After en-
tering the desired group, the monitoring values can be browsed by pressing UP /
DOWN button, as shown in Figure 7.4.
In MON menu the selected signal and its value are alternateing in the display by
pressing OK button.
Note! Turn on drive power, arrowhead of main menu is at MON, V x.x
or monitor parameter value of Vx.x is displayed in Panel.
Display Vx.x or monitor parameter value of Vx.x is determined
by the last show status before power shut down. E.g., it was
V4.5, and it is also V4.5 when restart.
OK
OK
OK
1
2
3
Press Left/Right to browse
other Monitoring groups
Prsess Down to
browse V4.5
5
Press OK V4.5 is display
4
Preess OK the value is
displayed
FAULTALARMSTOPREADY RUN
REF
MON
PA R
SYS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS FWD REV I/O KEYPAD BUS
Press OK to enter
Monitoring menu
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD R EV I/O KEYPAD BUS
FAULTALARMSTOPREADY RUN
REF
MON
PA R
SYS
FWD REV I/O KEYPAD BUS