User manual

control panel vacon • 65
24-hour support [phone] • Email: [e-mail]
7
V2.13 Analog output E2 % 32
Analogue output signal 2 in % from
option board, hidden until an
option board is connected
V2.14 DIE1, DIE2, DIE3 33
This monitor value shows status of
the digital inputs 1-3 from option
board, hidden until an option board
is connected
V2.15 DIE4, DIE5, DIE6 34
This monitor value shows status of
the digital inputs 4-6 from option
board, hidden until an option board
is connected
V2.16 DOE1, DOE2, DOE3 35
This monitor value shows status of
the relay outputs 1-3 from option
board, hidden until an option board
is connected
V2.17 DOE4, DOE5, DOE6 36
This monitor value shows status of
the relay outputs 4-6 from option
board, hidden until an option board
is connected
V2.18 Temperature input 1 50
Measured value of Temperature
input 1 in temperature unit (Cel-
sius or Kelvins) by parameter set-
ting, hidden until an option board
is connected
V2.19 Temperature input 2 51
Measured value of Temperature
input 2 in temperature unit (Cel-
sius or Kelvins) by parameter set-
ting, hidden until an option board
is connected
V2.20 Temperature input 3 52
Measured value of Temperature
input 3 in temperature unit (Cel-
sius or Kelvins) by parameter set-
ting, hidden until an option board
is connected
V3.1 Drive status word 43
Bit codes status of drive
B0 = Ready
B1 = Run
B2 = Reverse
B3 = Fault
B6 = RunEnable
B7 = AlarmActive
B12 = RunRequest
B13 = MotorRegulatorActive
Code Monitoring signal Unit ID Description
Table 7.2: Monitoring values