User manual

68 • vacon control panel
Tel. [phone] • Fax [phone]
7
In edit mode, Left and Right buttons are used to select the digit which has to be
changed, and Up increases / Down decreases parameter value.
In edit mode, the value of Px.x is displayed blinkingly in the panel. After about 10 s,
Px.x is displayed in the panel again if you don't press any button.
Note! In edit mode, if you edit the value and don't press OK button, the
value isn't changed successfully.
In edit mode, if you don't edit the value, you can press Reset /
Back button to display Px.x again.
7.4.5 System menu
SYS menu including fault submenu, field bus submenu and system parameter sub-
menu, and the display and operation of the system parameter submenu is similar to
PAR menu or MON menu.In system parameter submenu, there are some editable
parameter (P) and some uneditable parameter (V).
The Fault submenu of SYS menu includes active fault submenu and fault history sub-
menu.
Figure 7.6: Fault menu
OK
Press OK to enter V1.1
1
Press Left/Right button
to browse other groups
2
Press down to browse
other active faults
3
REF
MON
PA R
SYS
FAULTALARMSTOP
FWD R EV I/O KEYPAD BUS
READY RUN
OK
Press OK to select one fault
to browse its time
4
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD R EV I/O KEYPAD BUS
Browse for fault code(C xx),
subcode(Id xx), days(d xx),
hours(H xx), minutes(M xx)
5
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD R EV I/O KEYPAD BUS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS
REF
MON
PA R
SYS
FAULTALARMSTOPRE ADY RU N
FWD R EV I/O KEYPAD BUS