Operating instructions

Over/Under Checkweighing with Additional Requirements
Changing the Tolerance Limits
You can individually define the tolerance limits to be between 0.1% and 10%.
Tolerance limits Code
+/– 0.1% over/under deviation from the target 4 1 1
+/– 0.2% over/under deviation from the target 4 1 2
+/– 0.5% over/under deviation from the target 4 1 3
+/– 1.0% over/under deviation from the target 4 1 4*
+/– 1.5% over/under deviation from the target 4 1 5
+/– 2.0% over/under deviation from the target 4 1 6
+/– 2.5% over/under deviation from the target 4 1 7
+/– 3.0% over/under deviation from the target 4 1 8
+/– 5.0% over/under deviation from the target 4 1 9
+/– 10.0% over/under deviation from the target 4 1 10
Automatic Data Output
“Acceptable” values can be printed out or transferred automatically.
Data are output once the readout has stabilized within the tolerance limits selected.
Following data output, this function is blocked until the balance is unloaded to the
extent that the weight on the pan is below the lower threshold limit, or is loaded
so that the weight exceeds the upper threshold limit. The lower weight limit
is approx. 30% and the upper weight limit is approx.170% of the target weight.
Automatic output of “acceptable” values Code
On 4 2 1
Off * 4 2 2
* = factory setting
3–53