Operating instructions

Counting
Counting Code 2 1 4
Symbol displayed: P
Key identified in the display as follows:
– Before the program is selected STO
REF - F
– During counting OPT - F
The counting program allows automatic conversion of weights into piece counts
based on a reference sample weight identified by “wRef.”
You can store a reference sample weight and assign it to a reference sample
quantity “nRef” in one of the following ways using F, identified in the display
by “STO REF”:
– Place a sample on the pan and press the function key identified by “STO REF”
to have the reference sample weight “wRef” calculated from the sample weight
and
the reference sample quantity (piece count) “nRef” shown on the
application display
or
– Enter the reference sample quantity “nRef” using the numeric keys and store
it with the function key identified by “STO REF” to have the reference weight
“wRef” calculated based on this sample quantity and the sample weight
The reference sample quantity selected will be indicated on the application display
as long as you have not yet stored the reference sample weight.
To change the standard reference sample quantity, either access the parameter
mode or enter a different number and store it by pressing F identified by
“STO REF” (see page 3–58).
To toggle between the piece count and the weight readout, press the toggle key
labeled w.
3–55