Operating instructions

Automatic output of parameters Code
Off 7 1 1 *
Reference %/qty. + reference weight 7 1 2
Reference weight only 7 1 3
Automatic tare output/print Code
Individual tare weight 7 3 1 *
Total tare weight 7 3 2
Readout in percent Code
Only for For all
MC5 (-0CE), other
SC2 (-0CE) models
Without decimal 3 5 1 3 6 1
1 decimal 3 5 2 * 3 6 2
2 decimals 3 5 3 3 6 3 *
3 decimals 3 5 4 3 6 4
Differential Weighing and Backweighing
Weighing sequence Code
Only for For all
MC5 (-0CE), other
SC2 (-0CE) models
Individual weighing 3 6 1 3 7 1
Consecutive individual weighing 3 6 2 * 3 7 2 *
Combined weighing 3 6 3 3 7 3
* = factory setting
Fully Automatic Draft Shield
You can define the fully automatic draft shield function
to meet the most diverse requirements to combine work
procedures and make them easier. After you have
pressed a function key or after a control command has
been received, the draft shield will close automatically,
and the balance will then perform the particular function
activated by the key. If code 8 8 2 or 8 8 3 is set,
the draft shield will open once the function selected has
been performed.
Automatic draft shield function Code
Off 8 8 1
Shut/perform function/open 8 8 2
Shut/perform functon w/delay/open 8 8 3
Shut/perform function 8 8 4 *
Shut/perform function w/delay 8 8 5
Reset Function
This function enables you to reset all menu codes
back to the original factory settings, which are indicated
with an “*.” Set menu code 9 – – 1°, press t
to confirm; then press c.