Operating instructions

Data Interface
If you wish to record weight data using a Sartorius
Data Printer, plug the printer connector into the
interface port (14) of the balance. You do not need to
adjust any settings.
Important Note for Verified Balances Approved for
Use as Legal Measuring Instruments:
Make sure to unplug the balance from the power supply
(12) before you connect or disconnect
a peripheral
device (printer or PC) to or from the interface port (14).
To print data on hard copy or output them on the
screen of an on-line computer, press the p key (24).
For information about special data output parameters,
see
part 2, “Utilities” of the Balance Operating Menu.
For details on the data interface, see part 4,
“Interface Description.”
Interfacing Devices with the Balance
Please note that the interface port is electrically
connected to the protective grounding conductor
of the balance housing. The interface cables supplied
as standard equipment are shielded, and both ends
of each cable are electrically connected to the
connector cases.
This connection may result in interference caused
by ground loops or by transient currents if you have
grounded the housing or connected the protective
grounding conductor for AC power. If necessary,
connect an equipotential bonding conductor
to the balance.
When using the balance as a legal measuring
instrument, you may connect to it only
auxiliary devices that are legally permitted.
1–36
001: + 1608,628 mg
002: + 608,715 mg
003: + 722,744 mg
004: + 1722,655 mg