Operating instructions

Changing a Menu Code Setting
To select specific functions, you will need to set the
respective menu code.
There are three steps to changing a code:
– Accessing the menu
– Setting a code
– Confirming and storing this code
For setting menu codes, the keys have special
functions. To set a code, use the four keys which are
defined on the display as arrow points to indicate
the direction:
< w and > p = Move to the left or right
^
f and v F = Increase or decrease a number
by one with each press
t = Confirm a code setting
c = Store a code setting and exit
the menu
Now try changing the weight unit in the second
weighing range from grams to carats “ct,”
code 314.
Accessing the Menu (Example Code 3 1 4)
– Turn the balance off
– Turn it back on again
– While all segments are displayed, briefly press the
t key (10).
– If -L- is displayed, unlock the menu as follows:
– Remove the protective cap located on the
left-hand side of the balance’s/electronic computing
device’s rear panel to expose the menu
access switch
– Move the switch in the direction of the arrow
2–2