Installation guide

DOMELIGHT
~ (\
(-j DOOR SWITCH I M~) _
0-l-----------'------ DfA_2741r---(+-) 1-2-V -'1
Hl/6 BLUE (-) instant trigger input
This input will respond to a negative input with an instant trigger. It is ideal for
hood and trunk pins and will report on Zone 1. It can also be used with Directed
single-stage sensors. The Hl/6 blue instant trigger wire can also be used to shunt
sensors during operation of auxiliary channels or remote start. (See Bypassing
Sensor Inputs section of this guide.)
H 1/7 VIOLET (+) door trigger input
This type of dome circuit is used in many Ford products. Connect the violet
wire to a wire that shows (+) 12V when any door is opened. This wire will report
Zone 3.
NOTE: If using a door trigger wire that has a delay, Advanced Menu 2, feature
6 or the 998T Bitwriter can be used to turn Bypass Notification off.
DOMELIGHT
(+) DOOR SWITCH
lIJ
A
bl
01A·272 I
(+) 12V
~
I I
• •
l
H 1/8 BLACK (-) chassis ground connection
Connect this wire to a clean, paint-free sheet metal location (driver kick
panel) using a factory bolt that DOES NOT have any vehicle component
grounds attached to it. A screw should only be used when in conjunction with
a two-sided lock washer. Under dash brackets and door sheet metal are not
acceptable ground points. It is recommended that all security components be
© 2008 Directed Electronics- All rights reserved.
8