Specifications

JNS Engineering 14 3/18/2013
Defogger. Defogger can be remotely operated or will run automatically during
remote start if temperature is below 55°F. In this setup, a pulsed output should
be programmed.
Locks. Instructions provide for 1
st
remote unlock unlocks drivers door only; 2
nd
unlock unlocks passenger door – as with stock remote entry. Involves
connecting to the Keyless Entry Control Unit Located near left rear speaker
(behind panel). See note 1 in the wiring instructions for 1
st
remote unlock
unlocks both doors.
Factory Alarm. While it’s possible to set up the system to arm/disarm the factory
alarm when locking/unlocking the doors remotely, it involves the use of several
relays and diodes and is frankly not worth the effort required.
Clutch Switch. By installing the alarm’s starter wiring as directed, there is no
need to remove, disable or bypass the clutch switch which is also used by the
cruise control. It will continue to function normally when using the key to start the
car.
Starter connection. The alarm features anti-grind relay which prevents the key
from running the starter when the remote start feature is active. This involves
cutting one of the starter wires – the key side is connected to one lead and the
car (starter relay) side is connected to another lead. The recommended place to
make this cut is inconveniently located - connector is in upper right hand corner
of passenger footwell, but by using this location there is no need to bypass the
clutch pedal switch.
The Siren Options are limited due to size. I zip tied mine to the cross bar under
the bumper where the horns are located. It can also go inside the driver’s wheel
well if you remove the fender liner.
Positive Light Flash Output The brain box has a removable cover which covers a
jumper block. Set the jumper to Positive Light Flash Output to be compatible
with the 3000GT parking light circuit polarity.
Wire Lengths Some of the Viper 590x wires are not long enough to reach the
recommended destinations and will have to be extended. If the behind glove box
location is used for the brain the following wires will have to be extended:
H1-5 Parking light output
H2-3 Defogger (-) 200mA output
H2-7 Domelight 200mA (-) output
H2-8 Horn honk (-) output