Specifications

JNS Engineering 3 3/18/2013
General Description
The JNS Viper WIFI TOP
™
consists of programmed relays that simulate the
operation of the rocker switches for the top and tonneau. In the standby mode
the Interface is monitoring the level outputs of the car alarm system. When an
extra channel of the car alarm system is accessed by the remote control the
system wakes up and powers the Hardtop ECU. Depending on the channel
selected, the hardtop or tonneau is opened or closed according to programmed
timing.
Power to the system is applied only during the Viper programmed time to prevent
battery drain. Only a single operation at a time may be initiated by the Viper
remote and the operation continues until the programmed time expires unless the
same command is repeated in which case the operation immediately stops.
Functional Block Diagram
Figure 1 – Viper WIFI TOP
™
Block Diagram