Specifications

JNS Engineering 5 3/18/2013
Hardtop Close
An active low level on the Hardtop Close trigger places the car in “ON” mode and
actuates the Hardtop Close function for the duration of the Aux3 Viper timer. If
the safety stop is reached during Hardtop closure then the Hardtop will stop
movement and the “ON” mode will remain active until Aux3 times out. A second
press of the Aux3 function will complete the Hardtop closure. If the second press
occurs at the safety stop while Aux 3 is active then Aux3 will terminate and a
third press will immediately complete Hardtop closure.
If the safety stop is removed (see JNS Engineering TopLink manual) then a
single press of the Aux3 function can complete the closure if the timer is long
enough.
Specifications
Parameter
Pin
Test conditions
Min
Typical
Max
Units
Input voltage
1
12
V
Input current
1
Standby
5
mA
Trigger voltage
5,6,7,8
4
V
Sink current
5,6,7,8
Active trigger
5
mA
Output voltage
10,11,
12,13,
14
Active
12
V
Source current
14
Active
20
A
Source current
10,11,
12,13
Active
20
A
Tonneau open
time (Aux 1)
Programmed using
BitWriter
10
S
Tonneau close
time (Aux 2)
Programmed using
BitWriter
10
S
Hardtop open
time (Aux 4)
Programmed using
BitWriter
32
S
Hardtop close
time (Aux 3)
Programmed using
BitWriter
40
S
System active
time
1
S
Table 2 – Specifications
1
System remains active (“ON” mode) for the duration of the selected Aux function