Specifications

JNS Engineering 9 3/18/2013
Grey Wire: Hardtop Close Actuator (DB 25 Pin 13)
The D48 connector is located under the control switch garnish. Find pin 11 on
the connector. It will have 12V applied when the hardtop switch is operated to
the close position. Although the manual states this wire is Blue / White I found it
to be Light Blue in my car.
Clear Wire: +12V Ign2 Output (DB 25 Pin 14)
The D48 connector is located under the control switch garnish. Find pin 4 on the
connector. It will have 12V applied when the key is turned to the “On” position.
WIFI TOP
™
Module Location
The best locations for the interface module are under the rocker switches or
behind the ECU. To install the interface module you will need to loosen the trim
piece that holds the rocker switches in the center console. The interface module
at 2.6 x 4.25 x 1.12 is small enough to slip into the open slot. You can zip tie it to
the wire harness or use double-sided tape as you prefer. Simply plug the module
into the Interface harness making sure it is fully seated.
Viper 5904 Specific Programming
No programming per se is required. The Viper 5904 will operate the Top /
Tonneau functions as shown in the table
Viper 5904 Key Fob
Function
“Lock”
Lock
“Unlock”
Unlock
“ƒ” + “Aux”
Tonneau Open
2x “ƒ” + “Aux”
Tonneau Close
4x “ƒ” + “Aux”
Hardtop Open
3x “ƒ” + “Aux”
Hardtop Close
Table 4 – Viper 5904 Specific Programming
Troubleshooting the Installation
There are 5 LEDs to assist diagnosing problems with the installation; however
they are not viewable unless the case is opened. The LEDs indicate the active
timing cycle(s).
D2 = Tonneau Open LED
D5 = Tonneau Close LED
D11 = Hardtop Open LED