Installation guide

© 2004 directed electronics, inc.
37
smart power up II
The Smart Power Up II feature ensures that when the security system is powered back
up after being disconnected, the system will resume the same state it was in before
power was lost. For example, if power is disconnected during a full trigger sequence,
the system will still be in the full trigger sequence when power is reconnected to the
unit. If power is disconnected while the unit is disarmed, it will still be disarmed when
power is restored.
remote control sensor disable
1. Arm the system.
2. Use the transmitter to bypass the sensor.
3. The lights will flash four times. All warn away zones are now bypassed.
4. Transmit the sensor bypass channel again.
5. The lights will flash four times again. The sensor warn away and full trigger
zones are now bypassed.
6. The sensor zones will reset when disarmed.
sensors
shock sensor
The 504C dual zone magnetic resonance shock sensor provides a warning trigger for
lighter impacts to the vehicle as well as a full trigger for heavy impacts.
mounting the shock sensor
Mount the 504C sensor with wire ties or double-sided tape. Air ducts or wiring har-
nesses work well for mounting, although it is best to avoid harnesses containing light-
ing circuits.
adjusting the shock sensor
To adjust the sensor, turn the sensor screw clockwise for higher sensitivity or counter-
clockwise for less sensitivity.