User Manual

17 403.CHRYSLER6 2.04 2016 Dodge/Ram 1500

Feature programming

To enter feature programming routine:

1. Turn the ignition ON, then OFF.

2. Within 5 seconds, press and hold the programming button until the LED turns ON orange (after 3 seconds).

3. Release the Programming button.

4. The LED will ﬂash green once slowly to indicate the feature number is 1. After a short delay, the LED ﬂashes red rapidly to

indicate the current option of feature 1 (e.g. 1 x green followed by 1 x red indicates feature 1 is set to option 1). The ﬂashing

sequence will repeat until a new command is entered.

Changing feature options:

1. Press the lock/arm or unlock/disarm button on aftermarket transmitter to change the option of the selected feature.

2. The LED ﬂashes red rapidly the number of times equal to the current option number. After a short delay, the LED ﬂashes green

slowly the number of times to indicate the current feature. The ﬂashing sequence will repeat until a new command is entered.

Accessing another feature:

1. Press and release the programming button a number of times to advance from the current feature to the next desired feature.

2. The LED ﬂashes green slowly the number of times equal to the feature number. After a short delay, the LED ﬂashes red rapidly

to indicate the current option of the current feature. The ﬂashing sequence will repeat until a new command is entered.

When the maximum number of features or options is reached, the LED will start ﬂashing again from the ﬁrst feature or option.

Exiting feature programming:

To exit feature programming, press and hold the programming button for 3 seconds or ensure there is no activity on the interface

for 30 seconds. The LED will turn ON orange for 2 seconds to conﬁrm the end of the programming sequence.