User Manual
5 403.CHRYSLER6 2.04 2016 Dodge/Ram 1500
© 2017-01-26 Directed. All rights reserved.
Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THCHD3
Keys required for
programming
1
Keys required for
operation
0
The optional Plug & Play THCHD3 T-Harness is sold separately.
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
Key2GO is mandatory to control the immobilizer override in this firmware.
The keyless entry control on the OEM Key FOB used during Key2Go programming will not work while the vehicle is remote
started.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to "Vehicle connections" following the wiring diagram.
General notes: This section highlights important information for this specific firmware.
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[2] HS CAN 2 connections are required for heated seats.
Additional parts required (maximum required):
Diode 6A
0 x 1A Diodes
86 85
30
87a
87
0 x Relay
Resistor 100Ω
0 x Resistor
Fuse 7.5A
0 x Fuse