Installation guide

www.directed.com
34
horn output - pulsed/latched
z
Pulsed: H2/9 YELLOW/WHITE wire will generate a pulsing (-) output when the
alarm is in full trigger. When arming and disarming the output does not operate.
z
Latched: H2/9 YELLOW/WHITE wire will generate a constant (-) output when the
alarm is in full trigger. When arming and disarming the output will pulse as per
the standard chirp pulses.
auto immobilization - off/on
z
Off: Turns the auto immobilization feature off.
z
On: Turns the auto immobilization feature on.
programming notes
Note #1: Adding a new transmitter in auto-learn configuration
z
Press the arm/disarm button of the Radar 2 remote control; the siren will chirp once.
Note #2: Adding a new transmitter in custom-configuration
z
For the arm/disarm channel, transmit the channel of the new three, four, or five but-
ton transmitter that you want to control that feature; the siren will then chirp once.
z
For the rest of the channels, press the desired button on the remote to do the
specified feature.
NNOOTTEE::
When programming a new transmitter to custom configuration, an arm/dis-
arm channel must first be programmed before programming the remaining channels.
Note #3: Selecting siren sounds
After entering this feature, press the arm/disarm button. The siren will generate a five-
second sample of each available siren sound. Perform the following steps to add or
delete that specific sound.
z
Add sound: Press on the PlainView 2 Valet switch while playing the desired
sound to add that sound.
z
Delete sound: Press on the PlainView 2 Valet switch while playing the
desired sound to delete that sound.
Note #4: RPM programming
z
Drive the vehicle to an open area and allow the engine to warm up until the
engine RPM drops to normal idle speed.
z
Place the engine in park or neutral and set the parking brake.