Programming instructions

19
© 2004 directed electronics, inc.
z
Power Saver when the system is armed: After the system has
been armed for 48 hours, the LED will flash at half its nor-
mal rate, decreasing the system's current draw.
z
Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.
programming options
Programming options control what your system does during normal
operation, and require few or no additional parts. However, some may
require additional installation labor.
Following is a list of the program settings, with the factory settings in bold:
z
Active arming (only with the transmitter) or passive arming
(automatic arming 30-seconds after the last door is closed).
z
Arming/disarming confirmation siren chirps on or off.
z
Auto-Lock off/on/rpm
ON: The doors will lock three seconds after the ignition is
turned on unless a door is open.
RPM: The doors will lock when the engine speed increases.
z
Auto-Unlock on/off: With this feature on, the doors will
unlock when the ignition is turned off.