Programming instructions

36
seconds after the last adjustment signal from the transmitter and revert
to its previous settings.
The proximity sensor field takes one to two minutes to settle after
entering adjustment mode, so begin adjusting the sensor within 45
seconds and adjust it slowly so it has time to settle. After two minutes
you will have a consistent field during adjustment testing. Each zone
has 32 settings that are indicated by chirps that raise and lower in fre-
quency as adjustments are made. Total adjustment time for this sensor
should be five minutes or less.
Read the following instructions thoroughly for a full understanding of
how to properly adjust this sensor.
1. Disarm system
2. Transmit Channel 16. (Press 3 times then
1 time)
z
The LED will turn on and the siren will chirp 1 time.
z
Primary (full trigger) zone adjustment has now been
entered.
z
Primary zone can now be adjusted.
3. Adjusting Primary Zone
z
Press of the remote control to increase sensitivity.
z
Press of the remote control to decrease sensitivity.
z
The sensor Primary zone can be tested at any time dur-
ing adjustment and will generate 1 siren chirp each
time the zone is activated.
4. Press to enter Warn-Away zone adjustment
nnoottee::
You MUST exit using the ARM/DISARM button after program-
ming to lock in the new settings!