Programming instructions

29
© 2004 directed electronics, inc.
ters that have been lost, stolen, or incorrectly programmed
into the system.
z
After entering this feature press any button on the transmit-
ter; the siren will chirp to indicate that all transmitters have
been erased from memory.
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
Programming Procedure
1. Enter the feature location in the installer programming grid.
2. Immediately press and release of the PlainView 2 Valet
switch.
3. Select each digit by pressing 1-9 times, and then press
to enter the number into the system. To enter a zero,
press only.
To program a PIN code of 1032:
a. Press and release once and once. You will
hear one chirp.
b. Press and release once. You will not hear a chirp
after programming a zero.
c. Press and release three times, and then press
once. You will hear three chirps.
nnoottee::
A PIN code cannot begin with a zero.