OWNER’S GUIDE INSTALLATION GUIDE 15.4” (16:9) Overhead Video Monitor MODEL OHD1502 © 2004 Directed Electronics, Inc. N82104 05-04 .
Welcome! Thank you for your purchase of Directed’s Overhead Monitor with integrated DVD. Prior to operating this unit, please fully read this instruction manual and retain it for future reference. Warning! The overhead monitor system is designed strictly for rear-seat entertainment. Viewing the monitor while operating a motor vehicle can result in serious injury and/or property damage.
NON-TRANSFERABLE LIMITED CONSUMER WARRANTY Directed Electronics, Inc.
Important Information FCC NOTICE This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.
TABLE OF CONTENTS Safety Instructions and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Important . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Operating Monitor . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Instructions and Cautions WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK AND ANNOYING INTERFERENCE, USE ONLY THE INCLUDED HARDWARE. THIS MONITOR IS ONLY DESIGNED FOR REAR SEAT PASSENGER VIEWING AND IS NOT INTENDED FOR VIEWING BY THE DRIVER WHILE THE VEHICLE IS IN MOTION. SUCH USE MAY DISTRACT THE DRIVER OR INTERFERE WITH THE SAFE OPERATION OF THE VEHICLE, AND MAY ALSO VIOLATE STATE LAW.
Important WHEN CLEANING THE VEHICLE Do not spray this unit with water or cleaning solutions. Moisture and the chemicals found in cleaning fluids could damage the consoles finish and interior electronics. A soft damp, lens cleaning cloth should be used to wipe the screen. WHEN DRIVING This unit is intended for use in the rear seat area only. It should not be installed in a location that would allow the driver to view it while driving. WHEN PARKED The screen is easily removable.
This unit should be installed by an authorized Directed dealer. This product is designed to operate with a 12V DC, negative ground battery system. Disconnect the ground wire from the battery terminal prior to connecting the unit to the electrical system. The wiring from some other products or accessories might bear similar color code as this product; however, they might be of other function. Please refer to the electrical connection diagrams of this product prior to installing to avoid improper connection.
NOTE: The vehicle’s ignition key must be “ON” or “ACC” position for the monitor to have power.
Closing the Overhead Monitor Gently push the backside of the monitor until it clicks into the overhead monitor housing. The monitor will switch off automatically when it is returned to the closed position. to the closed position open position Setting the Screen Mode The overhead monitor has 4 different screen modes: FULL, NORMAL, WIDE and ZOOM. Pressing the MODE button on the front control panel or the remote control can access the different screen modes.
Function Keys 5 9 6 7 8 9 4 1 2 3 DISPLAY FUNCTION KEYS 1. Courtesy Light Button: Activate this switch to “ON/OFF” to activate the dome lights. 2. Open/Close Button Door Light On/Off Button: Engage this switch to have the door open switch activate the dome lights. 3. 4. IR Transmitter UNIT FUNCTION KEY 5. Power Button: Switch Audio/Video source. Press Power button over 4 seconds can switch on/off. 6. Selects the items to be adjusted. 7.
Remote Control PO WER IR FM PIP SO URC E MENU M ENU PBC TITLE IM AG E C LEAR DISPLAY SUBTITLE SLO W PRO G RAM ANG LE AUDIO MUTE REPEAT SETUP ZO O M ENTER MO D E 1 Power Button ○ ○2 IR Button ○3 FM Button ○4 Eject Button ○5 PIP Button ○6 Source Button ○7 Menu Button ○8 .
Replacement of battery NOTE : Before using remote after installation, remove the battery plastic protective slip. 2 1 1. Move the small latch to the right and slide out the battery holder. 2. Remove old battery and replace it with a new battery (CR2025) with the positive “+” sign facing as shown above. 3. Push battery holder back into its compartment until it is locked. Precautions 1. Properly dispose of used battery. 2.
Loading and Unloading Disc You can use single side and dual layer DVDs, VCDs, CD-audio and CD-R compatible 12cm discs with this system. Loading Discs 1. Press at the upper right corner to open the door. 2. Load with the recorded side (the shiny side) facing up. With double-sided discs, load with the side you want to watch facing up. Ensure that the disc is seated properly before pushing tray back into its locking position. 3. Push to close the door. Unloading Discs 1.
DVD Function Key 2 3 4 5 8 9 6 1 1 ○ ○3 ○4 ○5 ○6 ○7 ○8 ○9 1○0 1○1 1○2 1○3 1○4 7 Lock/Unlock Button Audio Button Menu Button Up Button Down Button Left Button Right Button Enter Button Play/Pause Button Stop Button MS Card SD Card CF Card 10 © 2004 Directed Electronics, Inc
DVD Playback Press the Power button on the player or the remote controller, and “Read” appears on the TV screen. If there hasn’t a disc in the DVD player, “No disc” will be displayed on the screen. Load a disc into the unit. The contents of each disc menu vary according to how the disc was authored and what features are included. The disc menu will be turned on for you to select, when Menu button pressed. Also play and pause can be switched with the Pause button on the remote.
3. In File Switch Region, you can press the Left and Right arrow buttons to switch the highlight, then press Enter. For example, if a disc with MP3 and JPEG files but without any Video files is loaded, the color of the letter “ ” and “ ” will appear to white and “ ” black. If a MP3 ” turns red. file playing, “ 4. To the disc with WMA, MP3 and JPEG files, when playing a JPEG picture, press the STOP button to return to JPEG list. 5. You can press the Numeric buttons to select the file you want to play.
(3) TV Type 4 : 3 PS (Pan & Scan): Choosing this setting if your DVD player is connected to a normal ratio TV. You can fill the movie to the entire screen of your TV. This might mean that parts of the picture (the left and right edges) won’t be seen. 4 : 3 LB (Letter Box): Choosing this setting if your DVD player is connected to a normal ratio TV. You’ll see the movies in their original aspect ratio (height-to-width ratio).
(6) Default Choose this option to resume all the setup options to default settings. SCREEN SAVER Language Setup (1) OSD Language The language setup options are illustrated below: The OSD Language Menu allows the user to select the language for the on-screen display. Highlight the OSD LANGUAGE option, and press the Arrow buttons to choose the OSD language you prefer. The user can select English, Chinese, German, Spanish, French, and Portuguese.
Installation About the Installation The installation of the overhead monitor system requires experience in both mechanical and electrical procedures. If you do not posses the necessary experience or tools to attempt this installation, contact a local Clarion dealer for assistance. Improper installation can result damage to the monitor and/or the vehicle. This manual provides basic installation tips and techniques to aid in the installation of the overhead monitor system.
Installation Procedure 1. Identify the polarity of the dome light circuit and set the switch on the bottom of the overhead monitor housing. 2. Test fit the overhead monitor system on the ceiling of the vehicle, verifying it is not going to interfere with the safe operation of the vehicle. 3. Once the mounting location of the overhead monitor system has been determined, carefully mark the location with masking tape. 4.
Connection Diagram If you are uncertain as to what the proper connections are. Please contact a qualified Directed technician for further installation assistance.
Complete System Diagram VCR YELLOW (+12V) Video Out BLACK (GEN ) Power OUT RED (ACC) IN DVD YELLOW (B+) BLACK (GEN IN DVD ) GRAY (Door Switch) IR Transmitter © 2004 Directed Electronics, Inc 19
Sample Installation Warning! Make sure that the screws you use to mount the bracket, monitor, or optional spacers are not to long! If the screws are to long, they will damage the roof of the vehicle. Take great care when planning this part of the installation.
Package Contents 1 Overhead Monitor 1 5M Power Cable 1 75cm Power Cable 1 Metal Mounting Bracket 1 Screws For Metal Mounting Bracket 1 IO Box 1 Trim Ring 1 Remote Control 21 © 2004 Directed Electronics, Inc
Troubleshooting No Picture Press the POWER and SOURCE buttons to make sure the monitor is on and the proper input is selected. If there is still no picture press the PICTURE button. If the menu appears, check the source unit and video connections. If NO MENU appears, check all fuses and power connections to the model. No Picture and Sound Press the [ A/V ] button to make sure you are not in A/V output. Picture Rolls Check that the T.V. type setting is correct for the monitors and DVDs being used.
Specifications System Laser Semiconductor Laser Signal Format NTSC, PAL Audio Characteristics Frequency Response DVD Video (PCM@96KHz) 20Hz-40KHZ∀1dB DVD Video (PCM@48Khz) 20Hz-40KHZ∀1dB CD 20Hz-40KHZ∀1dB Signal-to-Noise Ratio 90dB Harmonic Distortion 0.
