OWNER’S GUIDE INSTALLATION GUIDE 8” (16:9) Widescreen Overhead Video Monitor MODEL OHV 800 © 2004 Directed Electronics, Inc.
NON-TRANSFERABLE LIMITED CONSUMER WARRANTY Directed Electronics, Inc.
Table of Contents Non-Transferable Limited Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . .2 Important Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 What is Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Important Notes 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 4 Before operating your LCD Monitor system, please read these instructions carefully. Retain this manual for future reference. Do not remove any WARNING stickers on the unit. Do not use any chemical solvent, cleaning agent or corrosive detergent to clean away dirt on the surface of the screen. Doing so may cause irreversible damage to the surface of the LCD screen.
What is Included 8” Overhead Monitor Metal mounting plate Trim Ring Adapter 4-pin, 3-wire power harness AV Switch Box (AD-6869) 5-pin 5-wire dome lights harness 13-pin DIN source cable Hardware package Remote Control Unit/battery Introduction Congratulations on your purchase of the world’s finest video entertainment system. At Directed we are committed to bringing you the most technologically advanced products available. We are pleased that you chose a Directed Video product.
Installation PRELIMINARY PREPARATIONS NOTE: The unit should be installed by a qualified service technician. This unit is designed to operate with a 12 VDC, negative ground battery system. NOTE: Use only proper sized fasteners and cables during installation. Use of improper fasteners or cables can lead to mechanical failure of the unit or create a fire hazard. 1. Disconnect the ground wire from the battery terminal prior to connecting the unit to the electrical system.
ELECTRICAL CONNECTIONS Main Power Harness Color Black Yellow Red Description Chassis ground +12V Battery +12V ACC Courtesy Light Harness Color Black Red Gray Purple Yellow Description Chassis ground +12V ACC Door (negative trigger) Door (positive trigger) +12V Battery Audio Connections Color Red IN 1 (RCA) White IN 1 (RCA) Red IN 2 (RCA) White IN 2 (RCA) Red OUT (RCA) White OUT (RCA) Description Audio - #1 Right Input Audio - #1 Left Input Audio - #2 Right Input Audio - #2 Left Input Audio - Right Out
TYPICAL WIRING DIAGRAM Audio in 13-Pin DIN Source Cable A (R) RED-ACC YELLOW-BATTERY BLACK-GND BLUE-12 V OUTPUT 13 PIN TO MONITOR V AD-6869 ADAPTORS INPUT DC-13.2V FUSE 2A V A (L) OUT IN 1 A (L) A (R) SERIAL NO.
OHV Monitor Controls and Description 6 5 1 9 7 8 1. 2. 3. 4. 5. 3 4 3 2 LCD display ON/OFF/MODE button ( ) UP/DOWN buttons (S/T) MENU button ( ) Door light On/Off button ( © 2004 Directed Electronics, Inc. 6. 7. 8. 9.
Remote Control NOTE: Ensure that the battery plastic protector has been removed from the remote control battery holder prior to use. The frequently used buttons are described below. 1 CH/DISC/SET 4 POWER 1 2 3 4 5 6 MODE 2 MENU 3 MEMORY 7 8 9 0 MUTE SAVE BAND DISP VOL SCAN REP RC-1029A MOBILE AV REMOTE CONTROL 1. CH/DISC/SET (S/T)—use these buttons to adjust the selected setting on the MENU screen. 2. MODE—press this button to select the video source (AV1/AV2). 3.
Battery Replacement 1. Follow the instructions given in the illustration below to open the battery holder. 2. Remove the old battery and replace it with a CR2025 or equivalent. The positive (+) side of the battery must be facing upward in the clip. 3. Push the battery holder into the body of the remote control until the battery holder is locked. 4. Properly dispose of the old battery.
SIGNAL SOURCE SELECTION Select the input signal for viewing (AV1 or AV2) by momentarily pressing the MODE button ( ) on the LCD screen or the MODE button on the remote. ON/OFF CONTROL Press and hold the ( ) button on the LCD screen or momentarily press the POWER button on the remote.
NEGATIVE DOME LIGHT TRIGGER WIRE COLOR CONNECTION Gray Battery ground Blue Battery +12VDC Orange Battery +12VDC Purple Negative door trigger POSITIVE DOME LIGHT TRIGGER WIRE COLOR CONNECTION Gray Battery +12VDC Blue Battery ground Orange Battery ground Purple Positive door trigger COURTESY LIGHT ON/OFF Press the Courtesy light switch ( light. © 2004 Directed Electronics, Inc.
Specifications Type Display system Display format Roof mount color display monitor 8-inch active matrix color TFT LCD NTSC/PAL auto switch 112,320 pixels Aspect ratio 16:9 Resolution 112,320 DOTS/480 (W) X 234 (H) Active area 176 (W) X 99 (H) mm Back light 10,000 hours normal operation Mechanism Manual open/close Display angle Source Dome light Adjustable Horizontal: Up/Down <110º Composite video input x 2 Composite video output x 1 Audio L/R input x 2 Audio L/R output x 2 Infrared audio trans
System Configurations OPTION 1 Color Monitor/One Din DVD Player Digital Sound Processor Unit Video Out Audio Out (L) Audio Out (R) 12V Supply Audio In (L) Audio In (R) Optical Cable DSP Unit: DTS Sound Processor Speakers OPTION 2 Color Monitor/TV/Radio Tuner Amplifier / One Din DVD Player 12V Supply Video Out Audio Out(L)/(R) Proprietary DIN 9-Pin Cable Audio In (L) Audio In (R) Speakers / Power Supply 9-Pin Connector TV/Radio Tuner Amplifier Remote Control Antenna OPTION 3 Color Monitor/On
The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide consumers with the finest vehicle security, car stereo products, rear seat entertainment, and accessories available. The recipient of more than 20 patents in the field of advanced electronic technology, Directed is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world.