Specifications

Step By Step Installation

Step 1 Determine the location for the amplifier. Refer to the Choosing Mounting

Locations section of this guide for detailed information.

Step 2 Decide on the system configuration for your amplifier. For system sugges-

tions, refer to the Speaker Connections section of this guide.

Step 3 Run all the wires from the amplifier location to the speakers, source unit, and

battery. Do not connect the battery at this time. Be sure to run RCAs and

power and speaker wires away from factory electrical wires and system as

they pose a great potential for induced system noise.

Step 4 Pre-drill amplifier mounting holes. Be sure to "think before you drill". Gas

tanks, fuel lines, and other obstructions have a nasty way of hiding them-

selves. For best results use a marking pen to mark the mounting holes and

pre-drill these holes with a standard 1/8" drill bit.

Step 5 Mount the amplifier. Make sure the amplifier is mounted on a flat surface. If

this is not possible, do not over tighten the screws so that the chassis of the

amplifier is twisted or bent.

Step 6 Turn the vehicle's key switch to the off position.

Step 7 Disconnect the vehicle's battery ground terminal.

Step 8 Connect power wires to the amplifier (ground first, then 12 V(+) and REM).

Step 9 Connect the RCA and speaker wires to the amplifier. Check the quality of

your speakers and signal connections. This will determine the ultimate per-

formance of your WCC amplifier. Refer to the Signal Input and Output Level

Controls and Speaker Connections sections of this guide for correct wiring

instructions.

Step 10 Reconnect the ground terminal to the battery after power, speaker, and RCA

connections are completed.

Step 11 Set crossovers. Refer to the Internal Crossover Configuration section of this

manual for detailed instructions.

Step 12 Once satisfied that all connections and settings are correct, install the fuse

located near the vehicle's battery and proceed to the Testing the System sec-

tion of this manual.

NOTE! Never exceed the recommended fuse size of this amplifier. Failure to do so will

result in the voiding of your warranty and possible damage to the amplifier.

SET UP AND TROUBLESHOOTING

Testing the System

After you have completed the installation, you need to test the system. This will help ensure

years of trouble-free operation. Please refer to the listed steps below when testing the

sound of your WCC system.

Step 1 Check all the wiring connections to be sure they are correct and secure.

Step 2 Turn the signal source volume control all the way down. Set any tone con-

trols to their flat or defeated positions. This includes the loudness control.

Step 3 Turn the level controls of the amplifier to their minimum positions.

Step 4 Turn the source unit on. Check to see if the power LED located on the con-

nection side of the amplifier is on. If not, please refer to the Power

Connections and the Troubleshooting Tips sections of this manual for instruc-

tions.