Specifications

ManualsBrandsDirected Electronics ManualsAutomotiveORION WCC 1600.4

END PANEL LAYOUTS

6002

1. PWR (LED blue) - when illuminated indicates that the amplifier is on.

2. HI Input (high level input) - Accepts 1v to 10v input from the headunit’s speaker

output. The amplifier will automatically wake-up when the input is greater than

1V.

3. RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.

4. Level Control - continuously adjusts from 150mV to 5V for full power output.

5. Crossover Switch - activates low pass crossover, full (all pass), or high pass

crossover.

6. Low-Pass Frequency Control - adjusts the frequency (50Hz–500Hz) of the low-

pass crossover.

7. High-Pass Frequency Control - adjusts the frequency (50Hz–500Hz) of the high-

pass crossover.

8. Bass - sets the bass boost of the high-pass crossover to 0, 5 or 12dB of boost.

9. PRT (LED red) - illuminates when the PRT (Protection) function is active. Activates

to protect the amplifier when the temperature is too high, the output has a DC

offset, a short was detected on the output, or the amplifier power cables have

been improperly connected (reverse power). If the temperature, DC offset, or

short condition has cleared after approximately 10-seconds the amplifier will

automatically recover.

10. Speaker Connections - accepts two speakers or a bridge connection.

11. 2 ATC Fuses (25 amp) - protects the amplifier from over current situations.

12. Power Connections - accepts up to 8 AWG power and ground cables, and also

has a REM amplifier turn-on terminal (turns on the amplifier when fed +12 V).

HI-INPUT

INPUT

FULL

HPF

LPF

X-OVER

LEVEL

BASS

HI PASS

12dB

0dB

6dB

LOW PASS

500Hz

50Hz

500Hz

50Hz

90 90

0.83

1.5

0.15V

PRT

PWR

FUSEFUSE

BRIDGED

(L+)(R+) (L-)

(R-)

12 3 4 5 6 7 8 9

10 11 12

GND+12V REM