TWO-WAY LCD AUTOMATIC/MANUAL TRANSMISSION REMOTE STARTER WITH FULL ALARM SYSTEM PS-7870TWE-FM User Guide WARNING! It is the responsibility of the vehicle operators to ensure their vehicle is parked in a safe and responsible manner. 1. a) Manual transmission: When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged in order to avoid accidents upon remote starting.
Table of Contents GOVERNMENT REGULATIONS ................................................................................................................................................ 4 INTRODUCTION .............................................................................................................................................................. 4 VEHICLE PRESETS ....................................................................................................................................
What is EncryptR™ Technology? EncryptR™ employs proprietary encryption software that sends unique codes from the remote starter to the ADS-TB or ADS-AL-CA bypass module that cannot be replicated or reversed with hi-tech equipment. The EncryptR™ communication exchanged between the remote starter and the ADS bypass module is best described as a “secret handshake” that is never the same and changes every time it is used.
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Vehicle Presets Heater When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan) should not be left on HIGH. It is recommended to leave the settings on LOW or MEDIUM instead. Windshield Wipers, Radio & Headlights Certain vehicles energize the radio and / or windshield wipers and / or headlight circuits while running under remote start.
Side view: Function Button: -Turns ON the backlight -Allows access to Multilevel functions -Enters Programming mode Charger port: the battery charger plugs into this port. CAUTION!! DO NOT USE A CHARGER OTHER THAN THE ONE SUPPLIED.
a) Press the turn ON. for at least 1 second and release. The backlight should b) Within 3seconds, press the various functions. button for 2 seconds to access the Charging the Battery • Plug in the USB charger. CAUTION!! DO NOT USE A CHARGER OTHER THAN THE ONE SUPPLIED. • • The LCD displays “CHARGE” while the battery level bars within the battery icon flash. When charging is complete the LCD then displays “FULL”.
Remote’s advanced functions and MENU table: Display Description Parking meter countdown This version of the countdown feature is particularly useful for keeping track of parking meter time: the user may quickly set up the countdown using the Parking Menu. The transmitter will beep 6 times, 5min before the Parking countdown reaches 0 and beeps 6 times once the countdown expires. PARK to select MENU, then: Through Advanced Options, first press a. Choose PARK and press . b.
Through Advanced Options, first press to select MENU, then: a. Choose TSTART and press . b. Set the time at which you want to remote start the vehicle. First set the hour, and press . Then set the minutes and press . Choose ON and wait. A flashing “T” and will appear on the screen to confirm activation. Note: The TSTART function can only be carried out once per remote start. Secure function: This feature is used to lock the keypad of the transmitter to avoid accidental button press.
(13) ILLUM (14) If there is no activity within the programmed time, the keypad will automatically lock after 5 seconds, 10 seconds or 20 seconds. • Press for about 1sec, to unlock the transmitter’s keypad. LCD illumination: When this function is enabled, the LCD will illuminate each time Lock, Unlock or START is activated. Button Function: The order of LEVELS and MENU can be re-arranged using the Menu.
• • • 8. The to lock the doors and shut down the engine; to unlock the doors and shut down the engine; to shut down the engine without affecting the doors. icon will appear on your screen. Remote Starting 1. 2. 3. Press the button for approximately 1 second and release. The remote will beep once and the LCD will display “START”. The remote will confirm the remote starter’s activation by beeping 3 times.
Intrusion alert via remote The remote will beep or vibrate for about 60 seconds when an intrusion from door, hood, trunk, shock or ignition is detected. At the same time, the LCD remote will display “ALARM” and “DOOR / HOOD / TRUNK / SHOCK / real time” (depending on the type of alarm) alternately. The icons of door, hood, trunk and shock, as well as the red backlight, will be flashing (when the BLITE is set ON).
Idle Mode Convenience feature: Idle Mode allows you to keep the engine running and the doors locked while you stop, for example, at a convenience store or for a short delivery. (remove this part for IG) This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode: , or 1.
i) ii) c) Press the and buttons simultaneously until the icon appears on your LCD remote. The LED on the antenna will come ON solid to indicate that the vehicle has successfully entered Combo valet. To put the system into Combo Valet mode using the PUSH BUTTON SWITCH: i) Insert the ignition key into the ignition switch. ii) Turn the key into the ON position iii) Within 5 seconds, press the push button switch until the parking lights flash 3 times.
iv) v) Once the selection is done, press . Choose ON or OFF, then press and hold until; (1) The icon appears or disappears to confirm Combo Valet is enabled or disabled. (2) The icon appears or disappears to confirm Valet start is enabled or disabled. (3) The icon appears or disappears to confirm Valet Alarm is enabled or disabled. The system will warn you if someone attempts to remote start the vehicle while in Combo Valet and Valet Start. The parking lights will turn ON then OFF, then flash twice.
Extended Run Time While the vehicle is running under a remote start, press and hold the button for more than 3 seconds until the remote beeps 3 times. This will reset the run time counter to zero and restart the run time cycle from the beginning. The extended run time procedure can only be carried out once per remote start. To stop the vehicle, at any moment, simply press the button.
Relock If you unlock the doors with the remote transmitter, but do not open any door, hood, trunk or turn ignition ON within 30 seconds, the system will automatically relock and arm. Note: When the system is in active arming mode and the relock mode is enabled, the doors will relock but the system will not rearm. Remote finder This function will help you locate your remote. The unit will send a signal to the remote to trigger the remote to beep informing you of its location.
To keep your vehicle protected when the factory security system is disarmed for a remote start, Secure Lock will relock your doors as soon as the vehicle is started. Once the engine is shut down by remote or after its runtime has expired, Secure Lock will also rearm your factory security system and relock the doors.
2. 3. 4. 5. Remove the ignition key from the ignition switch. The engine will continue running. Exit the vehicle and close all doors, hood and trunk. button; this will lock the doors, arm the system alarm and confirm that the Press the vehicle is in Turbo Mode. The engine will shut down after 60 seconds. If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-10) to activate Turbo Mode.
• Active arming with disarm notification: This feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or when the Module is disarmed after being previously armed, the opening or closing of a Door will cause the Horn or the Siren to sound once after 10 sec. to warn the user that the vehicle was left or will cancel this timer. unprotected.
MultiLevel Features (default state) The multi-level features allow you to access different features of your vehicle or of a second car by button once, twice or three times. For convenience purpose, the order of LEVELS pressing the and MENU can be re-arranged through FBPRO setting (page-7). Features: • MENU: see page-7 for complete lists of MENU available. • Basic features: AUX-2, Cold Weather mode, Swap Start, Temperature request.
Troubleshooting Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) • Metal: any type of metal will affect operating range. This includes the vehicle itself. • The shape of the vehicle can affect range as well (vans in general have less range).
