User guide

P. 16 User Guide
ExtendedRunTime
While the vehicle is running under a remote start, press and hold the button for more than
3 seconds until the remote beeps 3 times. This will reset the run time counter to zero and restart
the run time cycle from the beginning. The extended run time procedure can only be carried out
once per remote start.
To stop the vehicle, at any moment, simply press the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter
to zero and allow the engine to run for another cycle (in this case, 3 minutes).
IntrusionCodesviaLEDlight
The system monitors the following:
• Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
• Doors
• Ignition
• Trunk
• Hood
Note: If an intrusion has occurred the siren will sound for a maximum of 1minute.
When an intrusion has occurred, pressing will make the siren chirps four times. The antenna’s
LED will provide an intrusion code corresponding to the type of the intrusion that occurred. The
LED intrusion codes are flashed in continuous loops.
2 x = Doors intrusion 5x = Panic
3 x = Shock Sense 6x = Ignition
4x = Hood 7x = Trunk
CarFinder™
When enabled, the Car Finder™ option will help you locate your vehicle by sounding a siren or the
horn. To initiate,
1. Through advance function remote’s menu (page-6), select L-01.
2. Press
to sound the siren once without affecting the door.
TemperatureRequest(IfACCTemp101installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
101) is installed:
• Through advance function remote’s menu (page-6), select L-01.
• Immediately press the button and hold it until the temperature is displayed on the
LCD screen.
TemporaryChirpDelete
To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g. in a
quiet neighbourhood):
• Press the
button. The remote will beep once.
• Immediately, press the
or button to arm or disarm system without any chirp.