User guide

User Guide P. 5

VehiclePresets

Heater

When leaving the vehicle it is recommended to preset the accessory controls in preparation for the

next remote start. Settings for the blower motor (fan) should not be left on

HIGH. It is recommended

to leave the settings on

LOW or MEDIUM instead.

WindshieldWipers,Radio&Headlights

Certain vehicles energize the radio and / or windshield wipers and / or headlight circuits while

running under remote start. When leaving the vehicle you must ensure that the windshield wiper

and headlight switches are OFF. Leaving the headlight switch ON on certain types of vehicles could

cause them to remain

ON even after remote starter shut down, resulting in a dead battery.

UsingtheTransmitter

Your remote starter is equipped with a 6-button, multi-channel, 2-way remote control. It can

operate two independent vehicles equipped with identical remote starters (see Multi-car operation

section on page 20).

LCDRemoteFunctions

The transmitter offers several command-confirmation and timer features. This section explains

some of the key functions available. The next section gives a summary of the button combinations

used to access the functions.

The functions of the transmitter are as follows:

Front view:

UNLOCK Button:

Unlocks all Doors and

disarms the Starter Kill (if

installed)

TRUNK Button:

Activates the Trunk

LOCK Button:

Locks all Doors and

arms the Starter Kill (if

installed)

START/STOP Button:

-Starts or Stops the engine (Normal functions).

-Starts the engine ONLY (if the Auxiliary Button is

programmed as STOP Button).

uxiliary

Button:

Activates AUX 2, stops the Engine,

sets the Temperature, activates

Panic Mode, activates CWM (if

programmed).